Total Pageviews

2,691

Sunday, January 16, 2011

The Gas fireplace upgrade

When I say upgrade the fireplace here is what I do.
The low voltage connections should be cleaned and soldered for a great electrical connection,why you ask well would electronics be as advanced if all the wire connections where just wire nutted or crimped "NO" "WAY"
The flame of the pilot generates less that 1/2 volt and less than 10 milliamps.
The piont is re-crimp and solder all gas valve millivolt connections.
Replace the wall switch because the contacts oxidies in a year or so.
Most wall switches have internal grease which can inhibite function of the the gas valve so excerising the switch on/off 10 times or so can clean the internal contacts and do this while the pilot flame is not lit.
So to recap,solder the millivolt connections,if using a thermostat bypass the anticapator by sliding dial to the solder piont.(mercury type)
Use an approved glass cleaner,also use compressed air with a double bagged vacuum cleaner to clean flue and fans and pilot.

2 comments:

  1. I just feel like you know so substantially and know how to make people listen to what you have to say. This blog is just too cool to become missed. Terrific stuff, really. Please, PLEASE keep it up!

    Gas Fitting Services Morington Penisula

    ReplyDelete
  2. Guru-contracting-best Plumbing, Heating Drainage guaranteed service provides home and commercial clients also for furnace, boiler,water heater repair.http://www.guruplumbing.ca/

    ReplyDelete